E-17
Operation
Basic Operations
4
3
3
Slide the ZOOM knob. The image can be adjusted
to the desired size within the zoom range.
4
Rotate the FOCUS ring until the image on the
screen becomes clear.
5
Press
INPUT
to select the desired input mode.
Press
INPUT
again to change the mode.
6
7
Projector
Remote control
ON/OFF
POWER
LAMP
TEMP.
KEYSTONE
INPUT
BACK
ENTER
MENU
AUTO SYNC
8
7
5
6
8
• When the selected input signal is being received, “Adjusting
The Image” will be displayed.
• When no signal is being received, “NO SIGNAL” will be
displayed. When a signal that the projector is not preset to
receive is being received, “NOT REG.” will be displayed.
f
5
d
g
s
INPUT 1
(COMPONENT) Mode
INPUT 1
(RGB) Mode
EXAMPLE
INPUT 3
(VIDEO) Mode
INPUT2
(S-VIDEO) Mode
6
Press
VOLUME
on the remote control to adjust
the volume.
7
Press
AV MUTE
on the remote control to
temporarily turn off the picture and the sound.
Press
AV MUTE
again to turn the picture and the
sound back on.
8
Press
ON/OFF
on the projector or
POWER
on the
remote control for over one second.
Press
ON/OFF
or
POWER
again while the
message is displayed.
• If you accidentally pressed
ON/OFF
or
POWER
and do not
want to turn off the power, wait until the power off screen
disappears.
• When
ON/OFF
or
POWER
is pressed twice, the POWER
indicator will light up red and the cooling fan will run for
about 90 seconds. The projector will then enter standby
mode.
• Wait until the cooling fan stops before disconnecting the
power cord.
• The power can be turned on again by pressing
ON/OFF
or
POWER
. When the power is turned on, the POWER indicator
and the LAMP REPLACEMENT indicator light green.
• The POWER indicator flashes if the right side filter cover is
not securely installed.
Summary of Contents for Notevision PG-C20XU
Page 11: ...E 10 Setup Connections Setup Connections ...
Page 53: ...SHARP CORPORATION ...