Appendix
45
PC control
A computer can be used to control the projector by connecting an RS-232C cable (null modem, cross type, sold
separately) to the projector. (See page 15 for connection.)
Communication conditions
Set the serial port settings of the computer to match that of the table.
Signal format:
Conforms to RS-232C standard.
Baud rate:
9,600 bps
Data length:
8 bits
Parity bit:
NON
Stop bit:
1 bit
Flow control:
None
Basic format
Commands from the computer are sent in the following order: command, parameter, and return code. After the
projector processes the command from the computer, it sends a response code to the computer.
RS-232C Port Specifications
Return code
(
0DH
)
C1 C2 C3 C4 P1 P2 P3 P4
Response code format
Normal response
O K
Return code
(
0DH
)
Problem response (Failure due to incorrect command/parameter or the other communication errors)
E R R
Return code
(
0DH
)
Command 4-digits
Parameter 4-digits
Command format
When more than one code is being sent, send each command only after the OK response code for the previous
command from the projector is verified.
• When using the computer control function of the projector, the projector operating status cannot be read to the computer.
Therefore, confirm the status by transmitting the display commands for each adjustment menu and checking the status with
the On-screen Display. If the projector receives a command other than a menu display command, it will execute the com-
mand without displaying the On-screen Display.
Summary of Contents for Notevision PG-C20XA
Page 11: ...Setup Connections 10 Setup Connections ...
Page 53: ...SHARP CORPORATION ...
