Operation
16
Operation
ON/OFF
POWER
LAMP
TEMP.
KEYSTONE
INPUT
BACK
ENTER
MENU
AUTO SYNC
2
Basic Operations
1
Make the necessary connections before pro-
ceeding. Connect the power cord to a wall outlet.
The POWER indicator illuminates red and the
projector enters standby mode.
• If the side filter cover is not securely installed, the POWER
indicator flashes.
POWER
LAMP
TEMP.
ON/OFF
KEYSTONE
Projector
Maintenance indicators
Remote control
2
Press
ON/OFF
on the projector or
POWER
on the
remote control for over one second.
• The flashing green LAMP REPLACEMENT indicator shows
that the lamp is warming up. Wait until the indicator stops
flashing before operating the projector.
• The power cannot be turned off for one minute after the
power is turned on.
• If the power is turned off and then immediately turned on
again, it may take a short while before the lamp turns on.
• After the projector is unpacked and turned on for the first
time, a slight odour may be emitted from the exhaust vent.
This odour will soon disappear with use.
• Do not press any buttons before the startup image
disappears. Before “Adjusting The Image” appears, only
ON/OFF
or
POWER
is available.
When the power is on, the LAMP REPLACEMENT indicator
lights indicating the status of the lamp.
Green:
Lamp is ready.
Flashing green:
Warming up.
Red:
Change the lamp.
POWER
LAMP
TEMP.
ON/OFF
KEYSTONE
Maintenance indicators
Summary of Contents for Notevision PG-C20XA
Page 11: ...Setup Connections 10 Setup Connections ...
Page 53: ...SHARP CORPORATION ...
