Sharp MX-M200D, Operation Manual

Page: 35 / 92

33
TROUBLESHOOTING AND MAINTENANCE
2
Misfeed in C
1
Lower (1) in the illustration, open the
fusing unit paper guide, and remove
the misfed paper.
Be careful not to tear the misfed
paper during removal.
2
If the misfed paper cannot be removed
by the previous step, remove it from
the paper output area.
Be careful not to tear the misfed
paper during removal.
3
Close the side cover.
The message " Clear paper
path." will be cleared and
copying will be possible.
MISFEED IN TRAY 1
1
Pull out tray 1 and remove the misfed
paper.
Be careful not to tear the misfed
paper during removal.
2
Open and close the side cover.
The message " Clear paper
path." will be cleared and
copying will be possible.
3
Gently push tray 1 into the machine.
Push the tray in completely.
The fusing unit is hot. Do not touch
the fusing unit when removing
misfed paper. Doing so may cause a
burn or injury.
(1)
Warning
• When closing the side cover, hold the
handle.
• If the paper was torn, make sure that no
torn pieces remain in the machine.
• If the message does not clear, check
again to make sure that no pieces of
paper remain.
Note
Make sure that there is no misfed paper in the tray before pulling it out. (Page 31)
Note
• When closing the side cover, hold the
handle.
• If the message does not clear, check
again to make sure that no pieces of
paper remain.
Note
Pegasus-E_Copy_Sec.book 33 ページ ２００９年６月４日 木曜日 午前１１時０分