MX-5111N MX-FNX9 (FINISHER) 9 – 2
2. Installation
NOTE: Before installation, be sure to turn both the operation and
main power switches off and disconnect the power plug
from the power outlet. Make double sure that the data lamp
on the operation panel does not light up or blink when per-
forming installation.
A. Removal of the paper holding arm unit
1)
Push up the section A to disengage the pawl, and remove the
paper holding arm and the paper holding arm holder together
as a unit.
* Be careful to remove both of the paper holding arm (which is
easily removed alone) and the paper holding arm holder.
B. Installation of the inner finisher
1)
Open the front cabinet. Remove two screws, and remove the
front cabinet upper.
2)
Disengage two pawls, and remove the paper exit tray cover.
3)
Remove four screws, and remove the paper exit tray.
* When removing the paper exit tray, there is no need to
remove the screws in the section (A).
4)
Remove the paper exit full detection actuator.
5)
Engage the projection on the main unit frame with the hole in
the finisher fixing plate (Packed items).
6)
Fix the right cover plate with the fixing screw (Packed items).
* Fix the side plate of the paper exit shifter with the fixing
guide.
2
1
A
A