MX-5111N MX-DE15/DE16 (STAND/1x500/2x500 SHEET PAPER DRAWER) 4 – 4
D. Connector connection
1)
Remove the screw from the back of the main unit. Remove the
connector cover.
2)
Connect the connector.
3)
Split the removed connector cover along the perforated line.
4)
Install the connector cover and fix it with a screw.
E. Turn on the power of the main unit
1)
Connect the power plug of the machine to the power outlet,
and turn ON the main power switch and the operation panel
power switch.
* For setting the tray size, refer to "Tray size setting" (2-9).
F. Off-center adjustment
(1) Adjustment with the simulation
1)
Run SIM50-10 using the keypad on the main unit.
The following screen appears:
2)
This screen allows you to configure the print off-center adjust-
ment value for each paper feed tray.
Detailed Description
3)
On the touch panel, press [
] to select "E: 50 :MAIN-CS3" or
"F: 50 : MAIN-CS4."
4)
Enter the desired adjustment value through the numeric key-
pad.
(This value, which defaults to 50, can be adjusted within the
range of 1 to 99).
• Reducing the adjustment value by 1 causes the main scan/
print position to shift by 0.1 mm toward the rear.
• Increasing the adjustment value by 1 causes the main scan/
print position to shift by 0.1 mm toward the front.
5)
After entering the adjustment value, press the [EXECUTE] key
on the touch panel to start printing and save the setting.
6)
Check that the adjustment pattern image is printed in the cor-
rect position.
Measure the dimensions of the void areas on the front- and
rear-frame sides of the adjustment pattern image, and make
sure that the following conditions are met:
No adjustment is needed if A - B = 0
3.0 mm.
If the above condition is not met, do the following:
7)
Change the adjustment value.
(Enter a new adjustment value and press the [OK] key).
Changing the adjustment value by 1 shifts the position by
approximately 0.1 mm.
Repeat steps 4) to 6) until the condition shown in step 6) is sat-
isfied.
8)
After you have completed the adjustment, exit from Simulation
mode by pressing the [CA] key.
Item
Display
Description
Setting
range
Default
E
MAIN-CS3
Print off-center adjustment value
(tray 3)
1 to 99
50
F
MAIN-CS4
Print off-center adjustment value
(tray 4)
1 to 99
50
ǂǂǂ6,08/$7,21ǂǂ12
7(67
3$3(5&(17(52))6(76(783
$˖
˷̚
˹
˖%.0$*
$˖
˖0$,10)7
%˖
˖0$,1&6
&˖
˖0$,1&6
'˖
˖0$,1&6
)˖
˖0$,1&6
(˖
˖0$,1/&&
*˖
˖0$,1$'8
+˖
˖68%0)7
,˖
˖68%&6
-˖
˖68%&6
.˖
˖68%/&&
/˖
2.
&/26(
(;(&87(
A-B =
0
3.
0mm
+
-
B
A
