E-2
ENGLISH
Position and method of installing wire controller
One end of the control wire of the wire controller is connected with main board of electric box of
indoor unit inside, it should be tightened by wire clamp, the other end should be connected with the
wire controller (Sketch map as shown in below). The control wire be used for the indoor unit and
wire controller, which is the special control wire, the length is 8 meters, the material be adopted
for the control wire should be metallic substance. The wire controller could not be disassembled
and the control wire be used for the wire controller should not be changed by users optionally, the
installation and maintenance should be carried out by the professional personnel.
2 Select an installation position. According to the size of the control wire of the wire controller, leave
a recess or a embedded wire hole to bury the control wire.
3 If the control wire between the wire controller and the indoor unit is surface-mounted, use #
metallic pipe and make matching recess in the wall (Refer to Figure ); If concealed installation is
adopted, # metallic pipe can be used (Refer to Figure 2).
4 No matter if surface mounting or concealed mounting is selected, it is required to drill 2 holes (in
the same level) which distance shall be the same as the distance (60mm) of installation holes in
the bottom plate of the wire controller. Then insert a wood plug into each hole. Fix the bottom plate
of the wire controller to the wall by using the two holes. Plug the control wire onto the control panel.
Lastly install the panel of the wire controller.
Caution:
During the installation of the bottom plate of the wire controller, pay attention to the direction of the
bottom plate. The plate’s side with two notches must be at the lower position, and otherwise the panel
of the wire controller cannot be correctly installed.
Caution:
•
The communication distance between the main board and the wire controller is 8 meters.
•
The wire controller shall not be installed in a place where there is water drop or large amount of
water vapor.
2
3
4
No.
Name
Wall surface
Bottom plate of wire controller
Screw M4X0
Panel of wire controller
1
3
4
2
Electric box cover
Cable-cross loop
Communication wire
Control wire
Wire clamp
Sketch map for indoor unit
control wire
metallic pipe
Figure :
Surface mounting of
cable
metallic pipe
Figure 2:
Concealed mounting of
cable
Schematic diagram of installation
GREE_duct_eng_1022.indd 21
08.10.27 3:32:13 PM
