Using TEL Mode
28
Putting a call on hold
To put the other party on hold during a
phone call, press
. When this is
done, they cannot hear you. You can put
the handset back in the cradle without
breaking the connection. When you are
ready to speak with the other party
again, pick up the handset. If you did
not put the handset back in the cradle,
press
again to resume
conversation.
Fax Signal Receive setting
The machine will automatically begin
reception if you hear a soft fax tone
after answering a call. If you prefer to
turn off automatic reception, follow the
steps below.
Initial setting: YES
1
Press , , ,
and .
2
Press
(YES) to turn on
automatic reception.
Press
(NO) to turn off
automatic reception.
3
Press
to exit.
F
Receive Ratio setting
Note:
This setting applies to all
reception modes.
The machine is initially set to
automatically reduce the size of
received faxes to fit the size of the
printing paper. This ensures that the
edges of a fax are not cut off. If desired,
you can turn this function off and have
received documents printed at full size.
♦
If a document is too long to fit on the
printing paper, the remainder will be
printed on a second page. In this
case, the cut-off point may occur in
the middle of a line.
♦
Automatic reduction may not be
possible if the received document is
too large, contains too many fine
graphics or images, or is sent at high
resolution. In this case, the remainder
of the document will be printed on a
second page.
Initial setting: AUTO
1
Press , , ,
and .
2
Press
(AUTO) to have
received faxes automatically
reduced.
Press
(100%) to have received
faxes printed at full size.
3
Press
to
exit.
F
