Set the drainpipe clip into the drainpipe to 2-3cm(from the drainpipe end without
hook). Then install the drainpipe into the drainpipe connector and fixed it with the
drainpipe clip. After that put up the drainpipe clip to fasten the grip.
1.Take off the drainpipe and drainpipe clip from the
drainpipe connector. Put soft mat on the floor and
gently put down the washing machine front side
on the mat. Unscrew the back cover by screwdriver
and gently unmount the back cover. Unscrew the
drainpipe connector (on the right of the washing
machine), then loosen the drainpipe connector.
3.With proper force, take off the drainpipe gate stopper
on the left side of the washing machine. The drainpipe
gate stopper is fixed on washing machine base with
two clips, look for the fixing orientation at the back
opening.
4.Pull the inner drainpipe to another side,
avoid distortion of the inner drainpipe.
As per foregoing description, fix the inner
drainpipe with the drainpipe hoop. Fix the
the drainpipe connector with the screw
and install the the drainpipe gate stopper
on the other side of the washing machine.
Gently stand the washing machine, fix the
back cover with screw and install the
drainpipe and drainpipe clip into the
drainpipe connector.
(Washing machine’s right side view)
(Washing machine’s inside view)
(Washing machine’s left side view)
The drainpipe should drain smoothly
1.The height of the drainpipe should be less
than 10cm, otherwise the drainage will not
be smooth and need a long time to drain,
the machine may stop during working.
2.Do not step on or press the drainpipe.
4. Purchase a proper hose if you need
additional drainpipe. Its diameter
should not be less than 30mm and
length should not exceed 1.5m.
If the additional drainpipe is too long,
cut some at A or B point.
A B
3.Cut the drainpipe if it is too long.
Cut the front end of the drainpipe slantingly
to make drainage smoothly.
Clean the lint filter
It is necessary to use lint filter during washing.
After washing, please clean the lint filter in
time.
Clean the lint filter according
to the following steps:
1. Pull out the lint filter.
2. Turn the filter net inside out
and wash it.
3. Reverse back the filter net
and remount it.
1. pull out magic filter
2. open the box and clean it
3. close it and reinstall it
4. check if the lint block part is in good
condition
Magic filter cleaning
press this part and pull out to take
out the magic filter
lint block part (black rubber)
Groove
