>10m
m
Tap selection
Suitable tap
Not suitable tap
The front end should be longer than 10mm. The tap exit end face
should be flat and smooth, if not file it to avoid leakage.
p
a
t
e
h
t
o
t
r
o
t
c
e
n
n
o
c
e
s
o
h
t
e
l
n
i
e
h
t
t
c
e
n
n
o
C
1. Press down the slider and remove the inlet hose connector from the inlet hose ,
like below illustration 1.
2. Loosen the four bolts on the inlet hose connector till the tap can be accessed, then
set the inlet hose connector in the tap, see illustration 2.(if the tap caliber is too large and
could not set the inlet hose end, unscrew the four bolts and take out the bushing, tap exit
end must be flat, otherwise it will leak, see illustration 3)
3. Fasten the four bolts in the inlet hose connector evenly, see illustration 4.
Remark: before twisting the nut, the threading is about 4mm above the upper surface of the nut, after twisting,
the threading is less than 2mm above the upper surface of the nut, see illustration 6.
4. Twist the fastening as seen on the illustration
.
When you reset higher water level than present:
When you reset lower water level than present:
Soak function
Child lock
Add water
When you choose “Normal” , “Speedy” , “Air Dry” , “Blanket” ,
“Soft” , “Baby” or “Delicate” program, you can use soak
function before wash.
After selecting the program, press “WASH” key for 2 seconds
to set soak function.
During wash (including rinse), press “WATER LEVEL” key to
add water as necessary.
Un-press will stop adding.
Or pause the washing machine by pressing “START/PAUSE”
key, and press “WATER LEVEL” key to select water level, then
press “START/PAUSE” key again.
.Before start
You can set child lock by pressing and holding
“WATER LEVEL” key and “PRESET TIME” key
at the same time for 3 seconds.
“CHILD LOCK” is displayed on the operation panel.
Press “START/PAUSE” and the machine is locked.
Press and hold these keys for 3 seconds again to
unlock this function.
.After start
You can set this function with the same way as ,
the machine is locked directly with the same way
as to unlock this function.
When you set this function, the wash procedure can not be
cancelled.
Press and hold
for 2 seconds
Press and hold at the same
time for 3 seconds
The washing machine will add water to the setting level
automatically and continue working.
The new water level will be valid in next water inlet.
1
1
1
2
