10
EN
Functional overview (cont’d)
Before you start
About the remote control
• Make sure there is no obstacle between the
remote control and the remote control sensor on
the unit.
• Use within the operating range and angle as shown.
• The maximum operable range as follows:
OPERATE
DV-RW370
OPEN/CLOSE
STOP
PLAY
STOP/EJECT
PLAY
REC/OTR
DVD
VCR
OUTPUT SELECT
DUBBING
PROGRAMME
(TRACKING)
REC/OTR
F.FWD
REW
PAL
REC MODE RAPID PLAY
SETUP
T-SET
OPEN/CLOSE
EJECT
TIMER PROG.
SHOW VIEW
DUBBING
OPERATE
Line of sight:
approximately
7m
Either side of centre:
approximately 5m
within 30 degrees
Above:
approximately
5m
within 15 degrees
Below:
approximately
3m
within 30 degrees
• Remote control operation may become
unreliable if the remote control sensor of the
unit is being exposed by the strong sunlight or
fluorescent light.
• Remote controls for different devices can
interfere with each other. Be careful when using
remote controls for other equipment located
close to the unit.
• Replace the batteries when the operating range
of the remote control reduces.
Installing batteries in the remote control
Install two R6 (AA) size batteries (supplied) into the
remote control, carefully match with the polarity
indicated inside the battery compartment.
Caution
• Incorrect use of batteries can result in hazards
such as leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus and minus ends of each
battery match the indications inside the battery
compartment.
• Remove batteries if the equipment will not be
used for a month or more.
• When disposing used batteries, please comply
with governmental regulations or the public
instructions for environmental protection that
apply in your country or area.
• Do not recharge, short-circuit, heat, burn or
disassemble batteries.
• Comply with the rules (ordinance) of each
local government when disposing of worn-out
batteries.
Child Lock function
This function protects any unexpected operations
by the kids when recording important programme
and so on.
1
Press and hold [RETURN
/
] for more than 5
seconds.
“LOC” will be displayed
on the front panel display
and the Child lock is now
activated.
• If any buttons (except for
[RETURN
/
]
) on
the remote control or the unit are pressed, “
”
will appears on the TV screen.
2
Press [RETURN
/
] again for more than 5
seconds.
“LOC” disappears and the Child lock will be released.
Note
• When One-touch Timer Recording or Timer
Recording has finished or if the power failure
occurs during Child lock is activated, the
function will be released.
3
1
2
http://www.usersmanualguide.com/