E-17
Enhancing your system
The connection cord is not included. Purchase a commer-
cially available cord as shown below.
Audio cable (not supplied)
Portable audio
player, etc.
■
Listening to the playback sounds of
portable audio player, etc.
1
Use a connection cord to connect the portable audio
player, etc. to the AUDIO IN jack.
2
Press the (ON/STANDBY) button to turn the power on.
3
Press the INPUT (AUDIO/LINE (INPUT)) button (main
unit or remote control) repeatedly to select AUDIO IN
function.
4
Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, adjust the volume of the
connected device.
Note:
To prevent noise interference, place the unit away from
the television.
■
Headphones
●
Do not set the volume on to maximum at switch on.
Excessive sound pressure from earphones and head-
phones can cause hearing loss.
●
Before plugging in or unplugging the headphone, re-
duce the volume.
●
Be sure your headphone has a 1/8” (3.5mm) diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
●
Plugging in the headphone disconnects the speakers au-
tomatically.
Troubleshooting chart
If something is wrong with this product, check the following be-
fore calling your authorized SHARP dealer or service center.
■
General
Symptom
Possible cause
●
The clock is not set to
the correct time.
●
A power failure occurred.
Reset the clock. (Refer
page 8)
●
When a button is
pressed, the unit does
not respond.
●
Set the unit to the power
standby mode and then
turn it back on.
●
If the unit still malfunc-
tions, reset it. (Refer page
18)
●
No sound is heard.
●
The volume level set to
“Volume Min”.
●
The headphones are con-
nected.
■
Remote control
Symptom
Possible cause
●
The remote control
does not operate.
●
The AC power cord of the
unit is not plugged in.
●
The battery polarity is
wrong.
●
The batteries are dead.
●
The distance or angle is
incorrect.
●
The remote control sensor
receives strong light.
■
Tuner
Symptom
Possible cause
●
The radio makes
unusual noises
continuously.
●
The unit placed near a TV or
computer.
●
The FM/AM antenna is not
placed properly. Move the
antenna away from the AC
power cord if it is located
nearby.
■
Bluetooth
Symptom
Possible cause
●
No sound is heard.
●
The unit is too far from the
Bluetooth
audio source
device.
●
The unit is not paired
with the
Bluetooth
audio
source device.
●
Bluetooth
sound is in-
terrupted or distorted.
●
The unit is too near to
a device that generates
electromagnetic radiation.
●
There is an obstacle
between the unit and the
Bluetooth
audio source
device.
