E-14
Listening to the radio
■
Tuning
1
Press the (ON/STANDBY) button to turn the power
on.
2
Press the TUNER (BAND) button (remote control)
or INPUT button (main unit) repeatedly to select FM
Stereo, FM Mono or AM.
3
●
Manual tuning:
Press the TUNING (
or
) button (remote
control) repeatedly to tune in to the desired station.
●
Auto tuning:
Press and hold the TUNING (
or
) button.
Scanning will start automatically and the tuner will stop at
the first receivable broadcast station.
Notes:
●
When radio interference occurs, auto scan tuning may
stop automatically at that point.
●
Auto scan tuning will skip weak signal stations.
●
To stop the auto tuning, press the TUNING
(
or
) button again.
To receive an FM stereo transmission:
●
Press the TUNER (BAND) button to select stereo
mode. “ST” indicator will be displayed. “
” and “ ” will
appear when an FM broadcast is in stereo.
●
If the FM reception is weak, press the TUNER (BAND)
button to extinguish the “ST” indicator. The reception
changes to monaural, and the sound becomes clearer.
■
Memorizing a station
You can store 40 AM and FM stations in memory and
recall them at the push of a button. (Preset tuning)
1
Perform steps 2 - 3 in “Tuning”.
2
Press the MEMORY button.
3
Within 30 seconds, press the PRESET ( or ) button
to select the preset channel number. Store the stations
in memory, in order, starting with preset channel 1.
4
Within 30 seconds, press the MEMORY button to store
that station in memory. If the “MEM” and preset num-
ber indicators disappear before the station is memo-
rized, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change
a preset station. When a new station is stored in the
memory, the station previously memorized for that pre-
set channel number will be erased.
Note:
The backup function protects the memorized stations for a
few hours should there be a power failure or the AC power
cord become disconnected.
■
To recall a memorized station
Press the PRESET ( or ) button to select the desired
station.
■
To scan the preset stations
1
Press and hold the PRESET ( or ) button until the
preset number flashes. The programmed stations will
be tuned in sequentially, for 5 seconds each.
2
Press the PRESET ( or ) button again when the
desired station is located.
■
To erase entire preset memory
1
Press the (ON/STANDBY) button to turn the power on.
2
Press the INPUT button (main unit) repeatedly or
TUNER (BAND) button (remote control) to select
Tuner function.
3
In Tuner function, press and hold the CLEAR button
(remote control) until “Tuner Clear” appears.
