Sharp AR-M161, Operation Manual

Page: 53 / 108

51
COPY FUNCTIONS
4
USING THE BYPASS TRAY TO COPY A SPECIAL SIZE ORIGINAL
When the bypass tray is being used for copying and an original that is placed on the document glass is detected as
being a special size, the display will prompt the user to set the original size. To make a copy in this type of situation,
follow the steps below.
1
Load paper in the bypass tray and
place the original on the document
glass.
2
Touch the [PAPER SELECT] key and
then select the bypass tray.
A message will appear asking you whether you wish to
set the original size or make the copy without setting it.
To make a copy without setting the original size, press
the [START] key (
). To set the original size, go to
step 3.
3
Press the [OK] key.
The original size selection screen appears with "SIZE
INPUT" selected.
4
Select AB or inches with the [ ] or
[ ] key, and then select the original
size with the [ ] or [ ] key.
5
Press the [OK] key.
If "SIZE INPUT" was selected in step 4:
The size entry screen appears and is ready for entry of
the width of the original.
If other than "SIZE INPUT" was selected in step 4:
You will return to the base screen. Go to step 8.
6
Select "X" (width) with the [ ] or [ ] key
and enter the width with the [ ] or [ ] key,
and then do the same for the length (Y).
7
Press the [OK] key.
You will return to the base
screen.
8
Press the [START] key ( ).
Copying begins.
POSURE
PAPER
SELECT
COPY
RATIO AUTO
IMAGE OUT
OUR MODE
ROGRAM
FORMAT
BROADCAST
RESOLUTION ADDRESS ORIGIN
[OK]:ORIG. SIZE
ENTER
100%
EXTRA
AUTO
GHI
OK BACK
ORIG. SIZE ENTER
A4R
A5
SIZE INPUT
AB
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
If you selected inches in step 4, the screen will
be ready for you to enter the width in inches.
• Any number from 64 mm to 432 mm (2-1/2"
to 17") can be entered for the width, and
any number from 64 mm to 297 mm (2-1/2"
to 11-5/8") can be entered for the length.
• The entered size is retained until the
power is turned off, even if "SIZE INPUT"
is selected again and the entry screen of
step 5 is displayed.
OK
SIZE INPUT
SIZE(mm)
X: 210
Y: 148
Note
SIZE INPUT
SIZE(mm)
X: 100
Y: 100
Note
OK
WXYZ
@.-_
READ-END
Pegasus-E_Copy_Ex.book 5 1 ページ ２００４年９月２３日 木曜日 午前１１時４１分