13
AF-06CSL
3. Open the window sash and place the air conditioner
on the sill.
Balance the unit on the sill and close the window
sash securely behind the top angle.
Indoor
side
1/2 inches
(13mm)
Indoor
side
WARNING:
At this step, make sure the unit
is inclined approximately 1 cm
(
3
/
8
") to the back.
If the unit is not properly in-
clined, the water collected in
the bottom tray during opera-
tion will not drain properly and
may flow into the room where
the air conditioner is installed.
4. Insert the bottom gasket into the space between the
window sill and the bottom of the unit to seal outside
air.
If there is space between the bottom channel and
the sill, fill the gap with a thin board or other hard
filler.
5. Insert the closure assemblies on both sides into the
rails of the jamb.
6. Loosen screws on both sides of the cabinet, then
hang the base pan angle on and secure the screws
again.
7. Secure the base pan angle to the sill by using the hole
of the front side on the angle with one screw. (L=1",
25.4mm)
8. Secure the top angle of the unit and the top of the
closure assemblies to the sash with three of the provided
screws. (L=1", 25.4mm)
And secure the bottom of the closure assemblies to
the sill with two of the provided screws. (L=1",
25.4mm)
9. Cut the window sash foam seal to the proper length
and seal the opening between the top of the inside
window sash and the outside window sash.
Bottom gasket
Jamb
(Left)
Sill
Stool
Closure assembly
(Left)
Closure assembly
(Left)
unit
sill
incline backwards approximately
1cm (
3
/
8
")
Top angle
Window sash foam seal