Shaper Origin S01-NN, Product Manual

Page: 11 / 32

shapertools.com 9
Basics
To change router bits, first unplug the SM1 Spindle
from Origin and remove it from the spindle mount,
as described earlier. Press the collet lock while
loosening or tightening the collet locking nut with
the included 19mm wrench. Do not tighten the
collet locking nut until a router bit is inserted.
WARNING: Maximum allowable cutter diameter is
1in (25.4mm).
To reinstall the spindle, slide it into the spindle
mount with the ON/OFF switch facing towards
you. A groove on the back of the spindle will only
allow it to be inserted in the correct orientation,
with the cable exiting on the left side. Gently re-
insert the spindle as to not deform the alignment
pin. IMPORTANT: Be sure to tighten the spindle
mount bolt after fully inserting the spindle into
the spindle mount. Finally, ensure the switch is in
the “OFF” position and plug the spindle cable back
into the side of Origin.
Changing the Router Bit