User’s Guide
HRP/S
-
19
-
HS
Adjustment
8
8.5
UPPER FILAMENT HEIGHT
Make sure that the lower and upper heating elements and the
pressure bars are in the correct position.
1.
Set the timer (
F
, page 12) to 990 sec.
With this time setting the machine will remain closed for
long enough to adjust the filament height.
2.
Place a test piece of the plastic to be processed on the
working surface.
3.
Lower the top frame by pressing the footswitch.
5.
Adjust the height of the filament using the adjusting nuts
on the upper heating elements.
You can set the filament to a minimum of 6 mm above the
plastic.
Adjust the height so that the element is clear of the plastic.
6.
Open the top frame with the emergency button (
C
, page
11) and reset the button.
7.
Reset the timer (
F
, page 11).
8.
Start the machine again as in Section
7
.
Adjusting nuts
5