www.shakmat.com
•
07/19
Flip the PCB and place the 3 pin
male headers, with the short pin side
through the hole. Be sure to lay them
flat and upright. Those headers will
later join the two PCBs together so
they need to be perfectly perpendicu-
lar.
We recommend you to only solder
one of the pin. Then reheat your
soldered point and simultaneously
press the plastic part of the header
against the PCB to until its flat on the
board. Release the soldering iron but
keep pressing. Avoid touching the pins themselves because they will become
hot very quickly and move out of alignment within their plastic bracket. Once
you are satisfied with you placement, solder the remaining pin.
4.2
Back
4.2.1
Male headers (1x3 pin) (x2)
P1
US2
We will solder these two headers one
by one. Place them, with the short pin
side through the hole. Use the same
procedure as for the smaller
headers. It is even more important to
have these two big headers upright
than the smaller headers.
4.2.2
Male headers (1x8 pin) (x2)
P1
US2
Summary of Contents for Four Bricks Rook
Page 21: ...www shakmat com ...
