www.shakmat.com
•
18/19
10. Potentiometers & buttons Caps
11. Powering & basic testing
Mount the five small button caps and
the 4 big ones. If they somehow feel a
bit loose, you can glue them on the
component with some gel glue. Just
be careful not to let the glue drain
down the button and destroy it!
At this step if a button is not sitting
properly on the front panel, you can
reheat its two solder points at the
same time and adjust it.
Finally, push the three knobs onto the
potentiometers.
Small button caps (x5)
P2
Big button caps (x4)
P2
Pot knobs (x3)
LP
Plug in the power cable and
make sure the red side of the
ribbon matches the -12V on the
PCB. Now let's plug the module
in your system and test it.
When powering up for the first
time, the module will launch a
first start up routine that lasts a
few seconds. During this routine
a green LED flashes. After the
routine and the module starts up
normally, the display should
show an alphanumeric character.
t The Trig Length & Play mode
LED should be on. If nothing is
on, turn off the rack immediately.
US2
JP1
SHAKMAT MODULAR
FOUR BRICKS ROOK v1.1
-12V
Summary of Contents for Four Bricks Rook
Page 21: ...www shakmat com ...
