www.shakmat.com
•
14/19
7. Front panel preparation
Place some masking tape over
every LED hole on the front panel.
Be aware of not blocking any other
component’s hole with the tape.
The LEDs are special flat top
models intended to be mounted
flush with the front panel. The
masking tape will help you to do
this neatly.
You also need to screw a small M3
nut on each of the two studs of the
back of the front panel. You can
screw them almost until the end of
the thread. In addition to these, two
other nuts added later will assure
the stability & alignment of the
PCB’s bottom half.
M3 nut (x2)
P2
Summary of Contents for Four Bricks Rook
Page 21: ...www shakmat com ...
