5.2.2
Male header (1x3 pin)
P2
www.shakmat.com
•
10/19
Place the 3 pin male header, with the short pin
side through the hole. Be sure to lay it flat and
upright. This header will later receive a jumper
and control the resonance amount.
We recommend you only solder one of the pins,
check the alignment. If necessary, reheat your
soldered point and simultaneously press the
plastic part of the header against the PCB until
it’s flat. Take off the soldering iron but keep
pressing. Avoid touching the pin itself because it
will become hot very quickly and move out of
alignment within the plastic bracket. Once you
are satisfied with you placement, solder the
remaining pins.
