www.shakmat.com
•
08/19
Before soldering, you will have to cut a little
metal piece off the top of each potentiometer,
as shown in the picture. This little stud prevents
the front panel from sitting properly. Use some
small & sharp cutting pliers for this task.
Then, place the 3 potentiometers on the PCB.
Mount the front panel and tighten the potentio-
meters nuts lightly (this will ensure a proper
placement of the pots) and then solder them.
Once you have soldered everything, remove the
nuts, the front panel and proceed to the next
step.
5.1.3
Potentiometers & nuts (x3)
P2
Cut!
3x
