SGM Technology for Lighting
GB
WIT074 V1.0-01NR
Idea Wash 575
22
ERROR CODES:
When power is applied, the unit will automatically enter “reset/test” mode. This mode brings all the internal
motors to a home position. If there is an internal problem with one or more of the motors an error code will
flash in the display in the form of “XXer” were as XX will represent a function number. For example, when the
display shows “05Er,” it means there is some type of error with the channel 5 motor. If there are multiple
errors during the start-up process they will all flash in the display. For example: if the fixtures has errors on
channel 5, channel 6, and channel 7 all at the same time, you will see the error message “05Er”, “06Er,” and
”07Er” flash repeated 5 times.
If an error does occur during the initial start-up procedure the fixture will self-generate a second reset signal
and try to realign all the motors and correct the errors, if the error persist after a second attempt a third
attempt will be made.
If after a third attempt all the errors have not been corrected the fixture will make the following
determinations:
1.
3 or more errors - The fixture cannot function properly with three or more errors therefore the fixture will
place itself in a stand-by mode until subsequent repairs can be made.
2.
Less than 3 errors - The fixture has less than 3 errors, therefore most other functions will work properly.
The fixture will attempt to operate normally until the errors can be correct by a technician.
The errors in question will remain flashing in the display as a reminder of internal errors.
01Er
(PAN-yoke movement error) This message will appear after the reset of the fixture if the yoke’s
magnetic-indexing circuit malfunction (sensor failed or magnet missing) or the stepping-motor is defective
(or its driving IC on the main PCB). The Pan is not located in the default position after the reset.
03Er
(TILT-head movement error) This message will appear after the reset of the fixture if the head’s
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the stepping-motor is defective
(or its driving IC on the main PCB). The Tilt is not located in the default position after the reset.
05Er
(Color wheel error) This message will appear after the reset of the fixture and if the magnetic-indexing
circuit malfunctions (sensor failed or magnet missing) or the stepping-motor is defective (or its driver circuit
on the main PCB). The Color wheel is not located in the default position after the reset.
07Er
(Magenta Color wheel error) This message will appear after the reset of the fixture if driving IC on the main
PCB is defective. The Magenta Color wheel is not located in the default position after the reset.
10Er
(Shutter wheel error) This message will appear after the reset of the fixture if driving IC on the main PCB is
defective. The Shutter wheel is not located in the default position after the reset.
11Er
(Zoom wheel error) This message will appear after the reset of the fixture and if the magnetic-indexing
circuit malfunctions (sensor failed or magnet missing) or the stepping-motor is defective (or its driver circuit
on the main PCB). The Zoom is not located in the default position after the reset.
15Er
(Effect wheel error) This message will appear after the reset of the fixture and if the magnetic-indexing
circuit malfunctions (sensor failed or magnet missing) or the stepping-motor is defective (or its driver circuit
on the main PCB). The Effect wheel is not located in the default position after the reset.
