16
Connecting AC power
The SP-6 SixPack can operate on any 100–240 V, 50/60 Hz AC mains power supply.
Connect the device to power using a cable with a Neutrik powerCON TRUE1 connector
(supplied with the fixture). The device can feed power to another device in a daisy chain
using the built-in 0.5 m (20 in.) power-out cable.
The device must be grounded/earthed and be able to be isolated from AC power. The AC
power supply must incorporate a fuse or circuit breaker for fault protection.
Due to the high level of in-rush current when the devices are started, ensure that no more
than:
•
4 SixPack devices—connected through the same type C, 10 A circuit breaker—are started at the same time.
•
9 SixPack devices—connected through the same type C, 16 A circuit breaker—are started at the same time.
For assistance with alternative configurations, contact your SGM agent.
After connecting the SixPack to power, run the automated on-board test to ensure that the device and each LED are
functioning correctly. Run the test by selecting “Test Automated→Test” from the control panel.
Do not open the fixture or connect the device to an electrical dimmer system, as this can damage it.
Summary of Contents for SP-6 SIXPACK
