SGM I-SERIES, User Manual

Page: 17 / 28

17
Supported RDM functions
The i-5 Series features support for various RDM functions.
RDM (Remote Device Management) is a protocol enhancement to USITT DMX512 that allows bi-directional communication between
the fixtures and the controller over a standard DMX line. This protocol will allow configuration, status monitoring, and management.
An RDM controller is needed to get control over the supported parameters. See the tables below for supported RDM functions.
RDM functions
RDM
Name Sensor Type
SMPS PCB Temperature
Pan PCB Temperature
Tilt PCB Temperature
Effect PCB Temperature
Base Temperature
Head Temperature
Red LED Temperature
Green LED Temperature
Blue LED Temperature
White LED Temperature
Led Left Temperature
Led Right Temperature
Angle Sensor 1 Other
Angle Sensor 2 Other
Name Sensor Type
CRMX Signal Strength Other
Wireless Paired Other
Humidity Other
Humidity Base Other
Humidity Head Other
Fan 1 LED RPM Velocity
Fan 2 LED RPM Velocity
Fan Base RPM Velocity
Fan Head RPM Velocity
Fan Zoom RPM Velocity
AC Power Connected Contacts
Battery PCT (percentage) Other
Battery Charging Contacts
Battery Voltage Voltage
PID Actions allowed Name
0x0080 GET Device Model Description
0x0081 GET Manufacturer Label
0x0082 GET / SET Device label
0x0090 SET Factory Defaults
0x1000 GET / SET Identify
0x00F0 GET / SET DMX Start Address
0x00E0 GET DMX Personality
0x00E1 GET DMX Personality Description
0x0200 GET Sensor Definition
0x0201 GET / SET Sensor Value
0x0400 GET / SET Device Hours
0x0401 GET / SET Lamp Hours
0x0500 GET / SET Display Invert (POI n.a.)
0x0501 GET / SET Display Level, 0=OFF, 1 and
above=ON ( POI n.a.)
PID Actions allowed Name
0x1001 SET Reset Device
0x8620 GET / SET Refresh Rate, 0= Standard, 1= High
Frequency
0x8623 GET / SET Dimming Curve, 0=Raw,
1=Gamma Corrected
0x8625 GET / SET FAN 0=AUTO 1=LOW
2=HIGH 3=FULL
0x8626 SET CRMX Log Off
0x8628 GET / SET Dim Mode, 0=Standard,
1=Max Power
0x8629 GET / SET Invert Pixel Order, 0=Standard,
1=Invert
0x8631 GET / SET Battery Extension, 0=Disable,
24=24 hour
0x8060 GET SGM Serial numberq
Please note:
The RDM controller communicates with the fixtures to show only the available options for each RDM function. The table is subject to change without notice.
Sensors
RDM enables various sensor readouts for remote device monitoring. See the table below for sensors and sensor types.
Please note:
The RDM controller communicates with the fixtures to show only the available sensors for this fixture. The table is subject to change without notice.