GB
appendice
page
9
I
D
F
E
3.10 Input signal
This function allows to choose which type of input signal is to be used, choosing between DMX
512 and RS-232.
For access to this function, scr oll with Up/Down until
or
appears. Then press ENTER, use Up/Down to select the required value, then
press ENTER again.
3.11 Pan/Tilt resolution
This function allows to set the resolution of the required movement at either 16 or 8 bits. As men-
tioned in chapters 3.3 and 3.5, these differ for the number of steps into which the mobile head’s
movement is divided.
In 16-bit (SGM) mode, the 540° Pan and 270° Tilt are divided into 65,536 steps, ensuring very
smooth precise movement. In 5-bit (STD) mode, there are 256 steps, which nevertheless give
precise movement.
To access this function, scroll with Up/Down until
or
appears.
Then press ENTER, use Up/Down to select the required value, then press ENTER again.
Remember to use the correct parameters in the configuration of the fixture in the Soft Patch of
the controller or desk to be used.
3.12 Remote lamp switching
Operators can decide if the lamp has to be switched on from the controller or automatically.
To access to this function, scr oll with Up/Down until
or
appears, where EN means enabled (active, i.e. via remote control) and DS
disabled (not active, therefore automatic). Then press ENTER, use Up/Down to select the value
required, then press ENTER again.
Remember to use the correct parameters in the configuration of the fixture in the Soft Patch of
the controller or desk to be used.
3.13 Remote fixture reset
Operators can decide when the Giotto can be reset from the controller or only run automatically
when the fixture is switched on.
For access to this function, scr oll with Up/Down until
or
appears, where EN stands for enabled (active, therefore under remote con-
trol) and DS for disabled (not active, so automatic). Then press ENTER, use Up/Down to select
the required value, then press ENTER. again
Remember to use the correct parameters in the configuration of the fixture in the software Patch
of the controller or desk which is to be used.
RST_CTR=DS
RST_CTR=EN
LMP_CTR=DS
LMP_CTR=EN
IN_MOD=STD
IN_MOD=SGM
SIGN=RS232
SIGN=DMX
