16
Rigging process
Start the rigging process by blocking the work area below, and make sure the work is performed
from a stable platform.
1
Check that the clamps are undamaged and can bear at least 10 times the weight of the
fixture. Check that the structure can bear at least 10 times the weight for all
installed fixtures, clamps, cables etc.
2
Bolt each clamp securely to an Omega bracket with an M12 / ½” bolt (min. grade 8.8) and
lock nut.
3
Align an Omega bracket with two 1/4-turns in the base. Insert the fasteners into the base
and turn both levers a full 1/4-turn clockwise to lock. Install the second Omega bracket.
4
Working from a stable platform, hang the fixture on a truss, or other structure and tighten
the clamps.
5
Install two safety wires that each can bear at least 10 times the weight of the unit.
The attachment points are designed to fit a carbine.
6
Check that the pan/tilt locks are released (A and B). Verify that there are no
combustible materials or surfaces to be illuminated within 0.3 m (11 in.) of the
fixture.
7
Check that there is no possibility of head or yoke colliding with other fixtures.
Locating the front of the fixture
• When the fixture is standing on the base; the front is to the right when looking at the display.
• When the fixture hanging; the front is to the left when looking at the display.
FRONT
