SGM 80031501, Manual

Page: 19 / 60

19
Connecting AC power
CAUTION: Do not connect the fixture to an electrical dimmer system, as doing so can damage the fixture.
The fixture must be grounded/
earthed and be able to be isolated
from AC power. The AC power
supply must incorporate a fuse or
circuit breaker for fault protection.
The P-1 can operate on any 100-240V, 50/60 Hz AC mains power supply.
Connect the fixture to power using a cable with a Neutrik TRUE1 power connector (supplied with the fixture).
The P-1 can also run on battery power, up to 12 hours with the possibility to extend the battery time up to 24 hours.
For permanent installation, have a qualified electrician wire the mains cable directly to a suitable branch circuit.
The ingress protection (IP) rating of the TRUE1 connector and junction’s must be suitable for the location.
The chassis mounted female TRUE1 power connector has to be covered when using the P-1 on battery power in order to
maintain the fixtures IP65 rating, i.e by utilizing the rubber cap mounted with the connector.