SGM 80031501, Manual

Page: 23 / 60

23
Connecting to a DMX control device
The P-1 is controllable using a DMX control device and it can be connected using either a DMX cable or via the fixture’s
build-in LumenRadio CRMX wireless receiver system.
If using a cabled DMX system, connect the DMX in- and output cables to the connectors on the rear of the base of the fixture
(chassis mounted 5-pin XLR connectors). Terminate the DMX out cable of the last fixture in the data link.
For outdoor installations, use only IP65-rated XLR connectors.
If using a wireless DMX system, ensure that the DMX connectors are properly covered.
Both DMX in and DMX out has to be connected or covered in order to maintain the fixtures IP65 rating.
Connecting a wireless transmitter
If the P-1 is not paired to a wireless transmitter it is designed to look for wireless transmitters in ‘connect’ state.
To connect the P-1 to a wireless transmitter:
•
Log off the currently paired wireless transmitter. See “Disconnecting a wireless transmitter” on page 23.
• Press the connect button on the wireless transmitter.
• Confirm that the fixture has paired with the wireless transmitter.
Disconnecting a wireless transmitter
To disconnect the fixture from the currently paired wireless transmitter:
•
Go to MENU → SETTINGS → WIRELESS DMX → LOG OFF.
Signal priority
The P-1 can be paired to an active wireless transmitter simultaneously as being connected to cabled DMX.
The fixture will prioritize cabled DMX over wireless DMX.
The active input type is displayed under the wireless signal strength indicator. See “Current input type” on page
22.