Pmag GB
Pmag
Electromagnetic flowmeter
Features
• Pipe dimension range:
DN10 ÷ DN1000
• Measure range:
<0,2m
3
/h ÷ >30000m
3
/h
• Fluid conductivity:
>5
S/cm
• Sensor material:
SS321
• Lining materials:
PTFE from DN10 to DN500;
rubber from DN40 to DN1000
• Housing materia:
epoxy printing aluminum
• Electrodes materials:
SS316; Hastelloy C
• Remote version operating temperature:
<80°C
• Compact version operating temperature:
-20÷75°C
• Accuracy:
±0,5%
• Repeatability:
±0,1%
• Analog outpu:
4÷20mA; max. load 750
• Communication protocol:
Modbus (opt.)
• Digital output:
0÷5000Hz
• Pulse output:
24Vdc pull-up
• Alimentazione:
85÷265Vac or 24Vdc
• Consumption:
<6W
• Protection compact version: IP67 with 4 cable
gland M16x1,5 for elect. connection
• Protection remote version:
IP67/IP68 only pipe
(opt.)
• Display:
backlit LCD
forward and reverse flow rate
direct, reverse and net total
General
A complete magnetic flowmeter system consists of two components: the Smag62 microprocessor-based integral-mount
magneti flowmeter transmitter and a flowtube.The flowtube is installed in-line with process piping, either vertically
or horizontally. Coils located on opposite sides of the flowtube create a magnetic field, and conductive liquid moving
through the magnetic field generates a voltage that is detected by two electrodes.The transmitter controls the generation
of the magnetic field and senses the voltage detected by the electrodes. Based on the sensed voltage, the transmitter
calculates a flow rate and produces analog and frequency output signals proportional to this flow rate.
Compact digital system, for conductive liquids (>5
S/cm),
even with a limitated content of suspended solids.
Measurement range: from <0,2m
3
/h to >30000m
3
/h
Typical measurement accuracy: ±0.5%
Power supply 85÷265Vac or 24Vdc
