5
Electrical installation
Hybrid ABOX "MTA...-I61.-...-00", "MTA...-G61.-...-00"
Operating Instructions – MOVIFIT
®
MC
81
5.10.3
Plug connector positions
NOTICE
The RJ45 socket can be damaged by inserting commercially available RJ45 patch
cables without a push-pull connector housing.
This will destroy the RJ45 socket.
• Only plug suitable push-pull RJ45 mating connectors according to
IEC PAS 61076-3-117 into push-pull RJ45 sockets.
• Never use commercially available RJ45 patch cables without push-pull connector
housing. These plug connectors do not snap in place when they are plugged.
Such cables can damage the sockets and are, therefore, not suitable.
The following figure shows the plug connectors of the hybrid ABOX:
[6] X21 – X24
[6] X25 – X28
[7] X50
[4]
X11
[5]
X12
MTA11A-503-G
61.
-...-00:
MTA11A-503-I
61.
-...-00:
[1] X75
[1] X75
X95 [3]
X95 [3]
X85 [2]
5798647691
[1]
X75
MOVIMOT
®
drive 1
(Intercontec 723 H-Tec,
7 + 3
‑
pole, female, code 3)
[2]
X85
MOVIMOT
®
drive 2
[3]
X95
MOVIMOT
®
drive 3
[4]
X11
Ethernet fieldbus, port 1
(push-pull RJ45, female)
(PROFINET, EtherNet/IP™, Modbus/TCP)
[5]
X12
Ethernet fieldbus, port 2
(push-pull RJ45, female)
(PROFINET, EtherNet/IP™, Modbus/TCP)
[6]
X21 – X28 Digital inputs/outputs
(M12, 5-pole, female, A-coded)
[7]
X50
Diagnostic interface
(RJ10, female, under the screw fitting)
INFORMATION
• The built-in M12 plug connectors have no specific alignment. This is why you
should only use straight M12 mating connectors.
• You find the pin assignment of the plug connectors in the "Electrical Connections"
chapter.
• To connect 2 sensors/actuators to an M12 plug connector, use the Y adapter with
an extension cable; see the chapter "Y adapter" (
19484828/EN – 01/2015
