6
Electrical installation
Protective measures against electrical hazards
Operating Instructions – MOVIPRO
®
PHE..B-A15-.1X0..B-00
37
Device with braking resistor
Preparing the braking resistor cable
Proceed as follows to install the braking resistor cable:
1. Remove the plastic sheath of the braking resistor cable [6] over a length of at least
260 mm.
2. Remove the shield of the braking resistor cable [6] over a length of at least 30 mm.
3. Fold back the braided shield over the plastic sheath of the braking resistor cable
[6].
4. Fix the braided shield in position with heat shrink tubing. Make sure that at least
20 mm of the braided shield remain blank.
5. Shorten the PE connection cable of the braking resistor [3] to at least 85 mm.
6. Crimp the ring cable lug for M5 to the PE connection cable of the braking resistor
[3].
7. Crimp a suitable female push-on connector (6.3 mm) to each of the remaining con-
ductors of the braking resistor [7].
Installing the PE
[1]
[2]
[5]
[3]
[7]
[4]
[6]
11951066763
[1]
M5 × 10 screw
[2]
Crimp cable lug for M5 (PE connection cable of the device)
[3]
Crimp cable lug for M5 (PE connection cable of the braking resistor)
[4]
Shield terminal
[5]
Housing
[6]
Braking resistor cable
[7]
Female push-on connector
1. Guide the shield terminal [4] over the braking resistor cable [6].
2. Place the shield terminal [4] onto the braided shield. Ensure that the braided shield
of the braking resistor cable is completely surrounded by the shield terminal.
3. Take a screw [1] and push the crimp cable lug [2], the crimp cable lug [3] and the
shield terminal [4] onto it.
4. Tighten the screw [1] with a maximum tightening torque of 2.5 Nm.
23576855/EN – 10/2017