2
P5080T
Installation Instructions
Visit the Premier Mounts website at http://www.premiermounts.com
Page 3
Parts List
Installation Tools
The following tools may be required depending upon your particular installation. They are not included.
Pencil
Level
¼˝ Drill Bit for
Wood Stud
Electronic Stud Finder
Socket Wrench
Phillips Tip Screwdriver
Tape Measure
Hand Held Drill
Hammer**
3
/
8
˝
Concrete Drill Bit*
Protective Eyewear
* Optional tools for concrete installations.
½˝ Socket
M10 Socket*
2
1
5/16
˝ x 3˝ Lag Bolts
(Qty 6)
Thread Depth Indicator
(Qty 1)
Universal Spacers
Finned Anchors
(Qty 6)
(Qty 24)
5/16
˝
Flat Washers
(Qty 6)
Pro Mounting Hardware
Universal Washers
(Qty 6)
Security Barrel
(Qty 1)
Wall Plate
(Qty 1)
Universal T
ilt Brackets
(Qty 2)
M6 x 60mm Screws
(Qty 2)
The following tools may be required depending on your particular installation. They are not included.
Tools for Installation
Important Safety Information
Prior to the installation of this product, read all instructions. Keep this manual for future reference.
Proper installation procedure by a qualified service technician must be followed as outlined in these installation instructions. Failure to
do so could result in property damage, serious personal injury, or event death.
Safety measures must be practiced at all times during the assembly of this product. Use proper safety equipment and tools for the
assembly procedure to prevent personal injury.
Séura does not warrant against damage caused by the use of any séura product for purposes other than those for which it was designed
or damage caused by unauthorized attachments or modifications, and is not responsible for any damages, claims, demands, suits,
actions or causes of action of whatever kind resulting from, arising out of or in any matter relating to any such use, attachments or
modifications.
At least two qualified people should perform the assembly procedure. Personal injury and/or property damage can result from dropping
or mishandling the TV.
If mounting to wall studs, make sure that the mounting screws are anchored into the center of the wall studs. Use of an edge-to-edge
stud finder is recommended.
Be aware of the mounting environment. If drilling and/or cutting into the mounting surface, always make sure that the wall is clear of
electrical wires. Cutting or drilling into an electrical line may cause serious personal injury.
Make sure there are no water or natural gas lines inside the wall where the mount is to be located. Cutting or drilling into a water or gas
line may cause severe property damage or personal injury.
Do not install near sources of high heat. Do not install on a structure that is prone to vibration, movement or chance of impact.
Tools for Wood Stud Installation
Tools for All Installations
Tools for Concrete Wall Installation
Stud Finder
1/2”
1/4” Wood Drill Bit
1/2”
1/2”
3/8” Concrete Drill Bit
Protective Eyewear
1/2”
Phillips Screwdriver
1/2”
Power Drill
1/2”
Pencil
Level
1/2”
Socket Wrench w/
1/2” Socket
1/2”
Tape Measure
1/2”
Hammer
1/2”
1/2” Combination
Wrench
1/2”
