15
P5080T
Installation Instructions
Visit the Premier Mounts website at http://www.premiermounts.com
Page 15
Leveling Screw Adjustment
If your flat panel is tilted too far to one side, the leveling
screws will allow you to compensate for this tilt by
adjusting the screws with a screwdriver.
Loosen both locking screws.
®
Adjust the tilt of your flat panel.
¯
Tighten both locking screws.
Caution!
It is possible to dislodge your flat panel while you
level your flat panel. Use extreme caution until
you tighten the locking screws.
Mounting Bracket Adjustments
Locking Screw Adjustment
After you have finished leveling your flat panel, be sure
to tighten the two (2) M6 x 120mm locking screws.
Do not overtighten the locking screws.
M6 x 120mm
Locking Screw
(1 per Bracket)
M6 x 30mm
Leveling Screw
(1 per Bracket)
Tilt Adjustment
Adjusting the Flat Panel Friction Tilt Angle
Place one hand at the center-top edge of the flat
panel.
®
Place the other hand on the center-bottom edge of
the flat panel.
¯
Using the upper hand, gently pull the top of the
flat panel towards you while the lower hand gently
pushes the bottom of the flat panel away from you.
Adjusting the Flat Panel to the Original Position
Place one hand at the center-top edge of the flat
panel.
®
Place the other hand on the center-bottom edge of
the flat panel.
¯
Using the upper hand, gently push the top of the flat
panel towards the wall while the lower hand gently
pulls the bottom of the flat panel away from the wall.
Tilt adjustment:
Adjusting the TV Tilt Angle
1. Place one hand on the center-top edge
of the TV.
2. Place the other hand on the center-
bottom edge of the TV.
3. Using the upper hand, gently pull the top
of the TV towards you while the lower
hand gently pushes the bottom of the TV
away from you.
Adjusting the TV to the Original Position
1. Place one hand on the center-top edge
of the TV.
2. Place the other hand on the center-
bottom edge of the TV.
3. Using the upper hand, gently push the top
of the TV towards the wall while the lower
hand gently pulls the bottom of the TV
away from the wall.
After tilt is adjusted to the desired position,
tighten the (2) tilt locking bolts on each
bracket until the brackets are firmly secured.
Do not overtighten the tilt locking bolts.
Tilt
Locking
Bolts
