9
5.0 Set "offset"
(please read before attempting procedure)
Note:
The channel must be calibrated before the offset is adjusted.
The "OFFSET" command allows you to adjust the reading relative to a known value.
To set the "OFFSET" use the following procedure:
Step 1.
Press and hold the
SCAN/adj
and
HOLD/mode
keys for 8 seconds, then release; the
display will alternate between "cal" and "noYes" for ten seconds
.
Step 2.
To specify "yes" and select "CH1", press and hold the
HOLD/mode
key to display
"CH1". (To select "CH2": With "CH1" displayed, press and release the
SCAN/adj
key
to display "CH2")
Step 3.
Press the
HOLD/mode
key to display "ALAr".
Step 4.
Press the
SCAN/adj
key to display "OFFST".
