Power connections
WARNING :
Before performing the following opera-
tions make sure the mains are disconnected. Before
powering the equipment, perform the controls foreseen in
paragraph “
Start up
”.
Place the power cord in the automatism paying careful
attention not to damage the cord against any metallic
edges. Connect mains and grounding wires on the terminal
board
(Fig. 19)
WARNING :
Never invert the power wire with the
grounding wire.
Power must be isolatable from the general panel with a bi-polar switch with minimum contact opening equal to 3 mm. (not
supplied).
Fig. 19
Installation Instruction
13
PIUMA MILLENNIUM
220V AC
Final operations
Before starting the automatism, check and perform the following:
•
Accurately remove and dust or shavings
•
Ensure the proper fixing of the automatism on the wall
•
Check correct tightening
•
Check that the wires are fixed and that no wire pass near the movement area.
•
Check that the arm is solidly fixed to the door and that it is equipped with the appropriate stop to limit the max opening
angle to 100°.
Transformer
fuse
(F 6,3A)
Power
switch
Transformer
connector
Battery
connector
Electronic lock
fuse (T 1A)
Electronic
lock connector
Motor
connector
Battery fuse
(F 6,3A)
Battery char-
ge board con-
nector
(optional)
Photocell
board connector
(optional)
Photocell ray
connector
(only used with optional
photocell board)
External peripheral
power fuse
(T 500mA)
External peripheral
power connector
External
peripheral
connector
Factory only
use connector
Dip Switchs
and selection
Jumpers
START opening
control button
PC
connector
Multi-logic
selector
connector
Fig. 20
Encoder
connector
MILLENNIUM Electronic Board
The meanings of the main electronic board components are listed in
Fig. 20
:
