SerVision
UVG400 Installation Guide
Connecting the UVG400 to a Power Source
The UVG400 must be connected to a standard wall outlet using the supplied power supply cable. Once it is
connected, it starts up automatically. During the start-up process, the LEDs on the front of the unit flash at various
intervals. When the start-up process is completed successfully, the
Power
LED should display as a solid color and
blink momentarily every second. (Depending on the configuration settings, it should either be solid orange and then
blink green or solid green and then blink orange.)
Power LED
Figure 15: Power LED
NOTE:
When the start-up process is completed, if the
Power
LED does not flash – it displays as a solid green
or orange all the time – the start-up process was not successful. In this case, disconnect the unit from
the power supply and then reconnect it.
WARNING:
Only the power supply cable that came with the UVG400 unit should be used. Use of a power
supply other then the one provided in the package may cause irreparable damage to the unit. If you
must use a different power supply, please inform your sales representative and request that a
DC/DC voltage stabilizer be installed in the UVG400 before it is delivered to you. (The cost of the
DC/DC stabilizer will be added to the base cost of the unit.)
D
To connect the UVG400 to a power source:
•
Connect the
Power
connector on the rear panel of the UVG400 unit to a standard wall socket using the
supplied power supply cable (see
The UVG400 Package
, page 5). The unit starts up.
Connecting the UVG400 to a Power Source
23