Servis-Rhino CY72, Operator'S Manual

Page: 13 / 136

SAFETY
CY72 01/08 Safety Section 1-7
© 2008 Alamo Group Inc.
SAFETY
There are obvious and hidden potential hazards in the operation of this
Mower. REMEMBER! This machine is often operated in heavy brush
and in heavy weeds. The Blades of this Mower can throw objects if shields are not
properly installed and maintained. Serious injury or even death may occur unless care is
taken to insure the safety of the operator, bystanders, or passersby in the area. Do not
operate this machine with anyone in the immediate area. Stop mowing if anyone is within
100 yards of mower.
(SGM-2)
All Safety Shields, Guards and Safety devices including (but not
limited to) - the Deflectors, Chain Guards, Steel Guards, Gearbox
Shields, PTO integral shields, and Retractable Door Shields should be used and
maintained in good working condition. All safety devices should be inspected
carefully at least daily for missing or broken components. Missing, broken, or worn
items must be replaced at once to reduce the possibility of injury or death from thrown
objects, entanglement, or blade contact.
(SGM-3)
The rotating parts of this machine have been designed and tested for rugged use.
However, the blades could fail upon impact with heavy, solid objects such as metal guard
rails and concrete structures. Such impact could cause the broken objects to be thrown
outward at very high velocities. To reduce the possibility of property damage, serious
injury, or even death, never allow the cutting blades to contact such obstacles.
(SGM-4)
Extreme care should be taken when operating near loose objects such
as gravel, rocks, wire, and other debris. Inspect the area before
mowing. Foreign objects should be removed from the site to prevent machine damage
and/or bodily injury or even death. Any objects that cannot be removed must be clearly
marked and carefully avoided by the operator. Stop mowing immediately if blades strike a
foreign object. Repair all damage and make certain rotor or blade carrier is balanced
before resuming mowing.
(SGM-5)
Many varied objects, such as wire, cable, rope, or chains, can become entangled in the
operating parts of the mower head. These items could then swing outside the housing at
greater velocities than the blades. Such a situation is extremely hazardous and could result in serious injury
or even death. Inspect the cutting area for such objects before mowing. Remove any like object from the site.
Never allow the cutting blades to contact such items.
(SGM-6)
Mow at the speed that you can safely operate and control the tractor and mower. The
correct mowing speed depends on terrain condition and grass type, density, and height of
cut. Normal ground speed range is from 2 to 5 mph(3-8 kph). Use slow mowing speeds when operating on
or near steep slopes, ditches, drop-offs, overhead obstructions, power lines, or when debris and foreign
objects are to be avoided.
(SGM-7)