KVM over IP Module
88 / 99
•
Thirdly, after the firmware has been stored, the panel will request you to reset the IP-KVM
manually. Half a minute after the reset, the IP-KVM will run with the new firmware version
and should be accessible. However, you are requested to login once again.
Warning
The three-stage firmware update process and complete consistency check are making
a mistake in updating the firmware almost impossible. However, only experienced
staff members or administrators should perform a firmware update. Make sure the
IP-KVM's power supply will not be interrupted!
5.6.4 Unit
Reset
Figure 5-34 Unit Reset
This section allows you to reset specific parts of the device. This involves the both keyboard
and mouse, the video engine and the IP-KVM itself. Resetting the card itself is mainly needed
to activate a newly updated firmware. It will close all current connections to the administration
console and to the Remote Console.
The whole process will take about half a minute. Resetting sub devices (e.g. video engine) will
take some seconds only and does not result in closing connections. To reset a certain IP-KVM
functionality click on the button Reset.
Note: Only the super user is allowed to reset the IP-KVM.
