Part Number 020004000
10/13
4-1
Section 4
Maintenance
Cleaning
DAILY CLEANING
All cleaning must meet your local health department
regulations. The following cleaning instructions are
provided as a guide.
Clean the exterior and drain pan
:
1. Turn off the key switch located on either right or left
side of the unit.
2. Lift the grid and remove it from the drain pan.
3. Using mild soap, warm water and a clean cloth, wipe the
drain pan and splash panel. Then, rinse with clean,
warm water. Allow plenty of warm (not hot) water to run
down the drain of the drain pan, to remove syrup
residue that can clog the drain opening.
4. Wash the grid, then rinse with clean water. Place the
grid back in the drain pan.
5. Wash all exterior surfaces of the unit with warm water
and a clean cloth. Wipe again with a clean, dry cloth.
Clean the dispensing valves:
6. Remove nozzles and diffusers from beverage valves.
Nozzle Removal
7. Rinse nozzle and diffuser with warm, clean water.
8. Clean nozzles and diffusers with soapy water and a
soft bristle brush.
9. Clean the underside of the beverage valves with
warm, soapy water. Rinse with clean damp towel.
10. Replace nozzles and diffusers on valves.
11. Turn on the key switch.
WATER BATH
It is recommended that the water bath be drained at
least twice a year. Turn off the refrigeration. Completely
melt the ice bank. Refill the water bath with fresh water
until water runs out the overflow tube. Turn on the
refrigeration.
!
Caution
Use only warm soapy water to clean the exterior of
the tower. Do not use solvents or other cleaning
agents. Do not pour hot coffee into the drain pan.
Pouring hot coffee down the drain pan can
eventually crack the drain pan, especially if the
drain pan is cold or still contains ice.
!
Warning
Electric Shock Hazard
Unplug unit before servicing or cleaning.
!
Warning
When using cleaning fluids or chemicals, rubber
gloves and eye protection should be worn.
Merchandiser
Soda Valves
Drain Pan Grid
Drain Pan
Splash Panel
Summary of Contents for CEV SERIES
Page 39: ......
