Sercel GRC DATA PRO, Operation Manual, Page: 31 / 93

Data Pro P/N 10029355 Rev AE
Operation Manual Page 31 of 92
8.4 About
The Data Pro firmware resides on the internally installed micro SD card.
Select the “About” menu to
display the Data Pro firmware version (
Figure 26
):
Menu

About
Figure 26
– Firmware and Contact Information
8.5 Interface Setup for FIC
Each FIC-1500 supports up to six channels and each channel represents multiple sensors. The Data
Pro application automatically detects connected FICs and identifies them with their connected gauges
(
Figure 27 ), accessed via following link below:
Main Menu

Interface Setup
The option,
‘Search for Interfaces’,
enables the user to perform a scan on the connected FIC based
on the entered addresses in
‘
Enter Start Search Address
’
and
‘ Enter End Search Address’
(Figure
30). The application default scanning range is
set from address one through eight. Perform ‘
Search for
Interfaces’
if the FIC has slave addresses outside of the default range. Once the scanning is complete,
the Data Pro displays the gauge tabs.
The option,
‘No Gauge Present, Disable Search’,
allows the Data Pro to run without any gauge
interface. This feature is used for demonstration or using the unit as a Modbus data collection device.
Figure 27
– Gauge Interface Search Window