FAULT IDENTIFYING GUIDE
PROBLEM
CAUSE
SOLUTION
FLASHING LIGHT RZ/07/1 F
!
NO
2 x 0,75 mm²
POWER SUPPLY
RG58
ANTENNA
CS/07 SR12.07
OPTIONAL CABLE
CONNECTIONS
230 Vac
OK
!
ATTENTION:
WE SUGGEST TO PLACE THE FLASHING-LIGHT FEEDER INSIDE AN INACCESSIBLE TUBE. ON THE CONTRARY,
ALL ACCESSIBLE PARTS HAVE TO GRANT A DOUBLE ISOLATION, MORE OVER IN ORDER TO AVOID THE TEAR OF
THE CABLE IT IS ADVISABLE TO USE A CABLE-HOLDER.
RZ/99
SR 10.99
ELBOW
SUPPORT
FOR REPLACEMENT,
USE LAMPS
240 V~ MIN ,
25 W E14
240 V~ MIN
The geared
motor does
not work
Faulty fuse
Change the fuse.
Power supply failure
- Check the presence of voltage at the power supply entry clamps to the
motor
- Check that the power supply cable is not cut off. The substitution of the
cable has to be carried out by an authorised technician.
The motor over-
heats
Stop the motor for 5 minutes and then try to make it work again.
Stop of the gate
Limit-switch set up
not correct
The gate
does not
complete its
run
Unlock the motor - see emergency monoeuvre - and move it by hand in
order to verify that there are no obstacles, if so, remove them. Picture
7A ÷ 7B.
Check the position of the limit-switch slide blocks and their working on
the spring for the micro-switch drive, adjust them.
Unsuitable
gearmotor position
Check that the distance between the end stop sliding plate and the front,
outgoing trim of the spring, adjust them.
The gate does
not startor the
motor slips
Clutch adjusting
not good
Take power supply off, and increase the setting of the motor power -
see point 7 ADJUSTING OF THE MOTOR POWER.
KI
T/
18
F-
18
H-
25
H
I
E
0
2
1
0
0
90
62
4
- A
4V
f/r
-
IS
K
IT
/1
8-
25
-I-
E
E L E T T R O N I C A P A D O V A
I
S
IN
C
E
1
9
6
5
M A D E I N I T A L Y
VIA ENRICO FERMI, 22
35020 LEGNARO - PADOVA
I T A L I A
PHONE +39 049 79 08 58
FAX +39 049 88 30 529
E-MAIL [email protected]
WEB www.serai.com
TERMS OF GUARANTEE
The company reserves the right to make modifications to the equipment without prior notice thereof. SERAI products are covered by a standard guarantee with a term of 24 months.
Coverage starts on the date on which the tax document constituting proof of purchase is issued and guarantee services shall be provided on the company's premises at Legnaro - PD -
or at the Authorised Service Centres. Carriage costs shall be borne by the Customer.
CE CONFORMITY DECLARATION
SERAI spa declares that the product KIT/18F, KIT/18H, KIT/25H was designed and manufactured according to the above mentioned directives and standards
WEEE DIRECTIVE 2002/96/EC
This appliance was manufactured after 13/08/2005. To protect the environment: when the equipment is no longer needed, take it to a special WEEE (Waste Electric and
Electronic Equipment) collection centre. Do not dispose of it with normal household waste.
