Sentera Controls MTY-7-15-AT, Mounting And Operating Instructions

Page: 5 / 8

www.sentera.eu
MIW-MTY-7-15-AT-EN-000 - 19 / 09 / 2019 5 - 8
back to the table of contents
OPERATIONAL DIAGRAMS
MTY-7-15-AT
120
40
Vout [VAC]
Maximum
speed
Minimum
speed
OFF
0
Knob
Position
WIRING AND CONNECTIONS
 Power supply (120 VAC ±10 % / 60 Hz)

Unregulated output voltage 120 VAC / max. 1,5 A for connecting a
lamp, valve, three-wire motor connection, etc.; branched off after
the input to bypass the potentiometer
N Neutral (power supply & unregulated output)
N Regulated output to motor, neutral
Regulated output to motor
Connections Cable cross section: max. 2,5 mm 2
MOUNTING INSTRUCTIONS IN STEPS
Before you start mounting MTY-7-15-AT, read carefully “Safety and
Precautions”
. Then proceed with the following mounting steps:
For inset mounting
1.
Remove the knob by turning it to the right until it pops out.
2. Unscrew the nut to remove the cover of the external enclosure.
3. Do the wiring according to the wiring diagram (see Fig. 1 Wiring and connections ).
MTY-7-15-AT
ELECTRONIC FAN SPEED
CONTROLLER