www.sentera.eu
MIW-MTY-7-15-AT-EN-000 - 19 / 09 / 2019
7 - 8
Fig. 3 Mounting dimensions - surface mounting
82
89
69
82
62
62
4.
Insert the cables through the grommets.
5.
Do the wiring according to the wiring diagram (see
Wiring and connections
).
6.
Insert the internal enclosure into the external one and fix it using the screws and
washers included in the set.
NOTE
Mount the unit so that the terminal block and connections are at the lower side.
7.
Using a flat screwdriver, adjust the Vmin trimmer (the factory setting is 100 VAC).
8.
Mount back the cover and secure it with the nut.
9.
Put back the knob and turn it to off position.
10.
Turn on the power supply.
NOTE
A 5 mm hole can be drilled at the bottom of the external enclosure to drain the
condensed water.
OPERATING INSTRUCTIONS
The controller is to be used only with voltage controllable fans / motors. You can
connect several motors to the controller as long as the current limit is not exceeded.
The motor used should be protected internally against overheating.
The trimmer is adjusted so that the motor does not stop due to mains voltage
variations. The controller restarts after power failure.
In case of faulty operation
Please check if:
■
the right voltage is applied;
■
all connections are correct;
■
the machine to be regulated is functioning;
■
the fuse of the controller is OK.
In case that the fuse has blown up, remove the knob by turning it to the right, beyond
the end stop and then pull. Open the cover and unscrew the nut. Remove the fuse
holder with the help of a screwdriver. Replace the fuse. Mount all the parts back in
place.
ATTENTION
Use only fuses with type and rating specified above; otherwise, loss of warranty
will ensue.
MTY-7-15-AT
ELECTRONIC FAN SPEED
CONTROLLER
