Sentera Controls FCMFF-R, Mounting And Operating Instructions

Page: 7 / 9

www.sentera.eu
MIW-FCMFX-R-EN-000 - 08 / 07 / 2020 7 - 9
back to the table of contents
4.
Mount the internal enclosure into the wall using appropriate connecting elements
(not included in the set). Mind the correct position and mounting dimensions
shown in
Fig. 2 and Fig. 3 .
Fig. 2 Mounting dimensions - inset mounting Fig. 3 Mounting position
38 15
58
82
82
89
76
58
58
52
Correct Incorrect
Position at min. 1,5 m
from the floor
5. Put back the frame cover of the enclosure and secure it with the screws.
6. Switch on the power supply.
7. Customise the factory settings to the desired ones via the 3SModbus software
or the Sensistant configurator. For the default factory settings, see the
Modbus
register map .
For surface mounting
1.
Disconnect the power supply.
2. Remove the frame cover of the enclosure.
3. Take out the internal enclosure.
4. Mount the external enclosure onto the wall using the dowels and screws included
in the set. Mind the correct position and mounting dimensions shown in
Fig. 4
and
Fig. 5
.
5. Insert the connecting cables through the grommets of the unit.
Fig. 4 Mounting dimensions - surface mounting Fig. 5 Mounting position
38 15
58
82
82
89
76
58
58
52
58
38
58
15
Correct Incorrect
Position at min. 1,5 m
from the floor
6.
Do the wiring according to the wiring diagram (see
Fig. 1
) using the information
from section “ Wiring and connections ”.
7. Put the internal enclosure into the external one and fix it using the delivered
screws and washers. (
Fig. 4 ).
8. Put back the frame cover of the enclosure and secure it with the screws.
9.
Switch on the power supply.
FCMFX-R
INTELLIGENT MULTIFUNCTIONAL
SENSOR