Sennheiser VMX OFFICE, Instruction Manual, Page: 15 / 28

11
En
gl
ish
To test the PC connection:
왘
Make sure the base station AUX
LED
쐄
is on. If not:
Press the AUX button
쐏
( ).
The AUX LED
쐄
is on now.
왘
Put on the headset.
왘
Dial up a contact with your VoIP soft-
phone.
왘
On the headset, press the hook
button
햶
.
왘
Have a conversation via the headset.
왘
End the call by pressing the hook
button
햶
on the headset.
If the communication stops and the
VoIP softphone ends the call, the
system is connected properly.
If the communication does not stop
or the VoIP softphone does not end
the call, please refer to the Senn-
heiser call control software manual.
Connecting a handset lifter to
the base station (optional)
When connecting a Sennheiser Commu-
nications handset lifter (e.g. HSL 10, see
“Accessories” on page 22):
왘
Connect the handset lifter to the
ACC socket
쐉
.
왘
Install the microphone as described in
the handset lifter manual.
왘
Attach the handset lifter to the
phone as described in the handset
lifter manual.
왘
Connect the TCI 01 as described in the
TCI 01 manual.
To test the handset lifter setup:
왘
Close and then open the microphone
boom
햵
.
The headset LED
햳
flashes once
every 5 seconds to indicate that the
headset is in standby mode.
왘
Press the PHONE button
쐇
( ).
The connection to the headset can be
established.
왘
Press either the hook button
햶
or
the PHONE button
쐇
( ).
A wireless link is established between
the headset and the base station.
The handset lifter lifts off the hand-
set automatically and the dial tone is
heard in the headset.
왘
If no clear dial tone is heard, please
refer to “Manufacturer declarations”
on page 23.
Before testing make sure
the PC works accordingly.
HSL 10
쐉