Sennheiser HMDC HMEC 300 400, Instructions For Use Manual

Page: 67 / 222

30
In case of difficulty
If problems occur that are not listed in the below table, please contact your Sennheiser
agent.
Problem Possible cause and what to do
Clear communication but no
active noise compensation The NoiseGard™ electronics are turned off.
왘
Check to see if the ON/OFF switch is set to “O N”.
The XLR-3 plug has been pulled out of the power source.
왘
Check to see if the XLR-3 plug is correctly connected to the power source.
If aircraft powered: The aircraft fuse is defective.
왘
Check the aircraft fuse.
If battery powered (except HMEC 302, HMEC 305 and HMEC 306): The batteries are low.
왘
Check to see if the green LED on the battery pack is lit. If the red LED is lit, replace
the batteries.
HMEC300US.book Se ite 30 Mittwoch, 7. April 2004 3:24 15