66
Mounting the bodypack receiver to a camera
Use the supplied camera kit to mount the receiver to the camera’s flash
mount.
The camera kit consits of:
!
1 perforated plate
7
!
1 flash mount adapter
8
!
2 square nuts
<
#
Determine where on the perforated plate the flash mount adapter
8
will
need to be fastened so that the receiver can best be attached to the
camera.
#
At this position, place a square nut
<
under the perforated plate
7
.
#
Fasten the flash mount adapter to the perforated plate using the square
nut.
#
Remove the belt clip.
#
Place the perforated plate
7
onto the rear of the receiver.
#
Reinsert the belt clip.
SK 100 G2 bodypack transmitter
Inserting and replacing the batteries
For powering the SK 100 G2 bodypack transmitter, you can either use two
1.5 V AA size batteries or the rechargeable Sennheiser BA 2015 accupack.
#
Press the two unlocking buttons
>
and open the battery compartment
cover
=
.
#
Insert the two batteries or the BA 2015 accupack as shown in the diagram
on the left. Please observe correct polarity when inserting the batteries/
accupack.
#
Close the battery compartment. The battery compartment cover
=
locks
into place with an audible click.
Note:
For important informations on charging the accupack see: „Inserting and
replacing the batteries“ on page 65.
Connecting the microphone/line cable
The microphone/line input is designed for the connection of both condenser
microphones and instruments (e.g. guitars). DC powering of the condenser
microphones is via the microphone/line input.
#
Connect the 3.5 mm jack plug
8
from the microphone/line cable to the
3.5 mm jack socket (MIC/LINE)
E
.
#
Lock the 3.5 mm jack plug by screwing down the coupling ring
<
.
#
Via the operating menu, adjust the sensitivity of the microphone/line
input (MIC/LINE) (see: „Adjusting the sensitivity (transmitters only)“ on
page 80).
7
8
<
4
3
3
!
<
8