63
Connecting the amplifier/mixing console
The EM 100 G2’s audio outputs are available as an XLR-3M socket
=
and a
¼” (6.3 mm) jack socket
>
, allowing you to simultaneously connect two
units (e.g. amplifier, mixing console). The adjusted audio output level is com-
mon for both sockets.
#
Connect the amplifier/mixing console to the XLR-3M socket
=
or the
¼” (6.3 mm) jack socket
>
.
For detailed information on balanced and unbalanced connection, please
refer to the section “Connector assignment” auf Seite 91.
#
Via the operating menu, adapt the level of the audio output (AF OUT) to
the input of the amplifier or mixing console (see: „Adjusting the audio
output level (receivers only)“ on page 81).
Service interface
The service interface
5
is only required for servicing purposes.
19” rack adapter and antenna mount
For mounting one or two receivers into a 19” rack, you require the GA 2 rack
adapter. The GA 2 rack adapter consists of:
!
2 rack mount “ears”
?
!
1 connecting bar
@
!
1 connecting plate
A
!
2 covering plugs
B
for antenna holes
!
12 recessed head screws M 3x6
!
2 recessed head screws M 6x10
When mounting only one receiver into a rack, you can use the AM 2 antenna
mount (available as an accessory) to mount the transmitter’s antenna con-
nection to the front of the GA 2 rack adapter. The AM 2 antenna mount con-
sists of :
!
2 BNC extension cables (screw-in BNC socket
C
to BNC connector
D
)
!
2 plains washers
!
2 nuts
3
4
5
@
A
B
?
D
C