4
ÿþþ
ÿþ
ÿ
ÿ
ÿþ
ÿ
ÿ
ÿ
þ
ÿ
ÿþ
þ
þ
þ
SW1-1, SW1-2, & SW1-3
ADDRESS GROUP SELECTION
for PELCO GROUPS OF 32
SW1
SW2
SW3
GROUP#
OFF
OFF
OFF
GROUP 1
ON
OFF
OFF
GROUP 2
OFF
ON
OFF
GROUP 3
ON
ON
OFF
GROUP 4
OFF
OFF
ON
GROUP 5
ON
OFF
ON
GROUP 6
OFF
ON
ON
GROUP 7
ON
ON
ON
GROUP 8
(These switches are ignored if SW1-4 is OFF)
SW1-4
ADDRESS GROUPING
ON: 8 GROUPS OF 32
OFF: 1 GROUP OF 255
Set to On if sending "P" code to re-
ceivers that have a maximum ad-
dress of 32 when configured for "P"
code.
SW1-8
KALATEL CODE TYPE
ON: DIGIPLEX III
OFF: DIGIPLEX II
SW1-7
KALATEL BAUD RATE
ON: 4167 for Digiplex II
4800 for Digiplex III
OFF: 2400 BAUD
SW1-6
KALATEL CONTROLLER
ON: VARIABLE SPEED
OFF: FIXED SPEED
SW1-5
PELCO TURBO SPEED
ON: ENABLED
OFF: DISABLED
When enabled, the highest Kalatel
speed is converted to Pelco's
"Turbo" speed command.
SETTING THE SWITCHES
SW3-1
PELCO CODE TYPE
ON: "P" CODE
OFF: "D" CODE
For "D" code, the output is 2400
baud. For "P" code, use SW3-2 to
select 4800 or 9600 baud.
SW3-2
"P" CODE BAUD RATE
ON: 9600 BAUD
OFF: 4800 BAUD
Both Kalatel and Pelco have multiple code types and baud rates. The code translator must be
configured to match the codes. To set the configuration switches, remove the back panel which is
secured by two screws. Then slide the cover back to expose the switches. Set the selected
switch to either ON or OFF. The switches can be changed while the code translator is powered up
and the new settings take effect immediately.
SW3-3
"P" CODE PARITY
ON: EVEN PARITY
OFF: NO PARITY
(Note: Set to even
parity for Pelco
CM9760CXTA)
